Toyota Camry

Fog Lights Wiring
I have a 2003 Camry that did not bring installed fog lights, but there are empty sockets to plug in lights at location where fog ligts would be installed in the front bumper. Is the 2003 Camry prewired for fog lights? If I install my own fog lights do I just "plug in" new lights into the empty sockets and add a fu... 13 Apr 2007 01:53

removing the rotors for replacement or grinding 94 camry
I AM TRYING TO REMOVE THE FRONT ROTORS FOR 94 TOYOTA CAMRY THE CALIPERS COME OFF EASILY BUT CANNOT SEEM TO GET THE ROTORS OFF, IS THERE ANY HIDDEN BOLTS OR SET SCREWS. -- Message posted via CarKB.com http://www.carkb.com/Uwe/Forums.aspx/toyota-camry/200704/1 ... 15 Apr 2007 00:15

How I Solved My Camry's Stalling Problem
> What Worked: Disconnected my EGR valve, and placed a 3-inch nail in the vacuum line. Car didn't stall anymore, but I didn't want to risk the higher engine temperature, and I wasn't too comfortable with the knowledge I'd fail a smog check. Worked when I had absolutely no choice though (stalling l... 18 Apr 2007 23:03

2003 Camry - replace serpentine belt
How do you release the belt tensioner to replace the serpentine belt? ... 7 Apr 2007 19:30

1999 Camry won't start.
My 1999 Toyota Camry won't start after being parked for 10 minutes. All accessories work fine, (radio, locks fan,signals etc) Anti theft has been bypassed. All fuses are working. The starter checks out fine. Could not find any broken electrical wires What can I possibly check? ventura1 ... 10 Apr 2007 11:07

grinding sound when stopping 99 Camry 4cyl
I'm getting a grinding sound coming from the front left wheel at very low speed just as I'm coming to a stop. I don't hear or feel anything when braking at moderate or high speeds. I pulled the wheel off and there's plenty of brake pad material left and the disc appears smooth. Any idea as to what this could ... 7 Apr 2007 12:16

How to remove EGR valve?
I'm trying to remove my EGR valve for cleaning ('96 camry, 141k miles, 4-cyl). There's one nut connecting the exhaust pipe to the EGR valve, that I absolutely cannot get off. I tried a plumbers' wrench, to get down that far - just can't get enough torque on that nut. Any suggestions? Just verifying, that nut... 18 Apr 2007 19:54

howto: remove a stripped Phillips screw
Hi all, Over the weekend, I removed my throttle body, cleaned with throttle plate cleaner solvent, then proceeded to remove the idle air control (IAC) valve for cleaning and inspection. There are four brass Phillips screws holding the IAC valve to the throttle body. (Why, oh why, couldn't Toyota make them hex... 3 Apr 2007 19:02

removing front signal light assembly
Father Guido, I have the same problem with my '98 Camry. Could you please assist with how to change the front blinker lightbulb? Bartek ... 30 Mar 2007 02:03

Gear Display Light Toyota Camry 2002
I have an Automatic 4-cylinder Toyota Camry 2002 and suddenly the light that illuminates the gears (in the middle of the front passenger seats) has stopped working. although it is not much of a hassle since I can still see the gears in teh front dashboard panel but it is inconvenient. My feeling it that it might a ... 25 Mar 2007 10:43